cle wifi reconnue en test primtux 3 mais pas apres installation

[almobator]

bonsoir,

merci pour le tuto mais la je bloque, j'aurais besoin d'aide
car apres impossible de scanner la wifi


:

Code :

[== Undefined ==]
: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host
       valid_lft forever preferred_lft forever
2: enp0s10: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc pfifo_fast state UP group default qlen 1000
    link/ether 00:26:2d:24:24:81 brd ff:ff:ff:ff:ff:ff
    inet 192.168.1.13/24 brd 192.168.1.255 scope global enp0s10
       valid_lft forever preferred_lft forever
    inet6 2a01:e0a:17d:b340:226:2dff:fe24:2481/64 scope global mngtmpaddr dynamic
       valid_lft 86207sec preferred_lft 86207sec
    inet6 fe80::226:2dff:fe24:2481/64 scope link
       valid_lft forever preferred_lft forever
3: wlx00117f07d648: <BROADCAST,MULTICAST> mtu 1500 qdisc noop state DOWN group default qlen 1000
    link/ether 00:11:7f:07:d6:48 brd ff:ff:ff:ff:ff:ff
administrateur@primtux:~$ ip link set dev wlx00117f07d648 up
RTNETLINK answers: Operation not permitted
administrateur@primtux:~$ su -
Mot de passe :
root@primtux:~# ip link set dev wlx00117f07d648 up
root@primtux:~# apt-get install firmware-misc-nonfree
Lecture des listes de paquets... Fait
Construction de l'arbre des dépendances      
Lecture des informations d'état... Fait
firmware-misc-nonfree is already the newest version (20161130-3).